Yield
–1.00 m²/m² = 10.76 ft²/ft²
An overlap of at least 3 cm is recommended.
An overlap of at least 3 cm is recommended.
Packaging
50 x 1 m Roll
Drying time
No need to dry out
Characteristics
Polites 80 is a fiberglass mesh used as reinforcement for Argacem finishing plasters to prevent cracks caused by the settlement of the substrate below. It provides adequate capacity to withstand impact and counteract the stresses due to thermal shock & curing, thus preventing the formation of cracks on Argacem HP finishing plaster. It is also suitable with smoothers applied on panels for thermal and acoustic insulation. It is supplied in 1.00m x 50m rolls (white colour).
Where to use it
Polites 80 should always be used locally at all stress points (corners of openings, around power sockets/boxes, over conduits etc) embedded within Argacem HP, Argatherm and Argatherm Acoustix.
Aspect: roll
Mesh width: 3.5 x 4.2 mm // 0.14 x 0.17 inches
Break Elongation: 4 %
Tensile strength 16.5 N/mm² // 2 393.12 lbf/in² (psi)
Technologically superior fiberglass meshes
for reinforcing waterproofing, plasters and liquid sheaths of all kinds.
- Quick and easy to apply.
- High longitudinal and transversal tensile strength.
- Resistant to alkali.
- Prevents the formation of cracks.